CANON GP160 PRINT DRIVER

Copy density correction is appropriate at a? Check the pressure nip width of the fixing pressure roller This machine has no adjustment mechanism for the fixing assembly nip width. Delivery sensor stationary jam If paper has not passed through the delivery sensor PS approx. The data which have been binarised are sent to the DC controller PCB with a recording resolution of x pdi equivalent. LUT 2 adj 8. The bit switches indicated on the display are as shown below.

Uploader:	Bragar
Date Added:	7 November 2014
File Size:	38.1 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	77525
Price:	Free* [*Free Regsitration Required]

When it is judged that a jam has occurred, the main motor is turned OFF, and a jam message is orint on the control panel.

When installing the document scanner motor, lock in position with a installation screw after pulling the tension spring between the motor and the main unit. Do not place in direct sunlight. Refer to 2 Remove the mylar sheet [1] and the sponge [2] from the upper part of the laser scanner unit.

Push down gently to avoid damaging the paper trailing edge position plate. Adjusting the output level No. When the cover is pribt up, the tab is disconnected from the catch. Operation outline The laser scanner motor is a 3 phase 8 pole DC brushless motor integrated, with the laser scanner motor drive circuit.

The printer continuously prints a diagonal line pattern in fine mode and characters in normal density.

Is there dirt on the contact point that YES Clean the pritn Cartridge pri2 supplies high-voltage to the carpoint. CCD will be selected. With the three level cassette feeder, in the lowest cassette feeder there is no interface connector provided between this and a lower feeder.

NO Check from Item When there is paper remaining of the same gpp160 as the paper that was used up, the add paper indicator does not display. LUT 1 fno 7. The image becomes faint due to moisture condensation in the scanning assembly glass, mirror, lens, etc. NO Replace the faulty sensor.

The procedure is as described below. This switch is only compatible with V machines.

Canon GP Toner Cartridge Black AAA -

If paper other than the recommended paper is being used, explain to the user that this may cause an inferior image. The service mode in this machine is structured along the lines of the conventional facsimile service mode, and its contents and operation methods comply with that mode. Outline The construction of this unit, which g160 the indirect method electro-static process, is shown in Figure Pritn this manual, the accessory one level cassette feeder unit D1 and the accessory three level cassette feeder unit E1 are called the cassette feeders.

When there was no detection of the zero cross signal temperature control reference signal after turning on the power of the main unit. Numeric key pad 0 1 2 3 4 5 6 7 8 Output speed bps bps bps bps bps TCbps TCbps bps bps Remarks: Does the dirt occur at random? Used when changing the senders name. Is the front cover completely closed? Setting the date and time User mode operation No.

Canon GP160

J on the image processor PCB properly connected? Completion tone settings SW No. Designates relay origination transmission.

The function of primt PCB is listed below.

Are there any creases or skewing on the copy paper at this time? Accumulated canin data in the memory are cleared. If the problem cassette is a cassette feeder cassette, replace the corresponding feeder controller PCB.